📋 Affiliate Disclosure: As an Amazon Associate, we earn from qualifying purchases. This doesn't affect our editorial independence or the price you pay. Learn more

Home & Living

Stiltz vs Pneumatic Vacuum Elevator: Specs, Power and Cost Compared (2027)

Stiltz vs pneumatic vacuum elevator: drive, footprint, capacity, wheelchair access, 220V power, travel, outage behavior and published cost ranges compared.

By Price Review TeamPublished 8 min read

Black Friday 2026: Amazon's sale runs through Cyber Monday, November 30. See our picks worth watching

Disclosure: Links to brand websites in this post are not affiliate links today. If that changes, we'll say so here. This post is not sponsored.

Stiltz vs Pneumatic Vacuum Elevator: Specs, Power and Cost Compared (2027)

The Short Answer

For a two story home on a tighter budget, a Stiltz through-floor lift is usually the better fit. Published cost ranges for Stiltz start lower, the Trio Alta takes a full size wheelchair plus a helper at 550 lb, and it has no minimum room temperature in the documents we read. A Pneumatic Vacuum Elevators (PVE) unit makes more sense when you need 3 to 5 stops or up to 50 ft of rise, want a very small round footprint (the PVE30 tube is 30 in across), or like the clear tube look. Neither plugs into an ordinary 120V outlet.

We did not test either brand. Every spec below comes from Stiltz's or PVE's own pages, spec sheets and manuals. Cost figures come from Angi, Fixr and RetirementLiving, with the date we read them.

How They Work

Stiltz uses a "roped drum, braked gear motor drive" in the roof of the car, according to its Duo page. The car rides on two freestanding vertical rails, so Stiltz says no load bearing wall, shaft or machine room is needed. It passes through a hole cut in the ceiling.

PVE moves the car with air pressure. Turbines at the top of the tube pull air out to lift the car, and gravity brings it down. The tube is self supporting and sits on the floor, with no pit, hoistway or machine room, according to PVE's spec sheets.

Side by Side (Manufacturer Specs)

SpecStiltz Duo AltaStiltz Trio AltaPVE30PVE37PVE52
DriveRope drum, gear motorRope drum, gear motorVacuum (3 turbines)Vacuum (5 turbines)Vacuum (6 turbines)
Footprint8.5 sq ft48 7/8 x 38 1/16 in max30 in round tube37 in round tube52 11/16 in round tube
Rated load375 lb550 lb350 lb450 lb525 lb
People1 to 22 to 3, or wheelchair plus helper123, or 2 with a wheelchair
Entrance24 5/8 in31 1/2 in20 in20 1/2 in32 in
WheelchairNot statedYesNoNoYes
PowerDedicated 220V outlet220 to 240V, 10 to 20A220 to 240V, 30A220 to 240V, 30A220 to 240V, 40A
Speed5.9 in/sec (about 29.5 ft/min)3 15/16 in/sec nominal, 5 7/8 max40 ft/min40 ft/min35 ft/min
Max travel4,500 mm (about 14 ft 9 in), one floor19 ft 8 1/4 in, up to 3 floors50 ft, 5 stops50 ft, 5 stops50 ft, 5 stops
Upper ceiling height93 in min.96 in min.107 in overhead (97 in split)samesame
Power cutBattery lowers carBattery lowers carGravity descentGravity descentGravity descent
Warranty24 month parts24 month parts1 year limitednot confirmed1 year limited

Stiltz sources: the Duo page, US Duo Alta spec, US Trio Alta spec, US brochure and FAQ. PVE sources: the PVE30, PVE37 and PVE52 spec sheets plus the PVE30 and PVE52 pages.

Both brands' documents disagree in spots. PVE's PVE52 page lists 30 ft/min and 35 amps, while its spec sheet lists 35 ft/min and 40 amps. Stiltz's 2023 US brochure says the Trio Alta's 550 lb may be limited to 500 lb by local code. Confirm numbers for your exact unit with the dealer.

Footprint and Space

The PVE30 has the smallest footprint here: a 30 in round tube, about 4.9 sq ft by our math from that diameter. The Stiltz Duo Alta takes 8.5 sq ft, and the PVE37 tube is 37 in across. For wheelchair models, the Trio Alta measures 48 7/8 x 38 1/16 in at most (about 12.9 sq ft by our math, though Stiltz's brochure says 15 sq ft), while the PVE52's 52 11/16 in tube works out to about 15.1 sq ft.

Height is a real difference. PVE needs at least 107 in of overhead clearance with its standard head unit, or 97 in with a split unit. Stiltz lists a minimum upstairs ceiling of 93 in for the Duo Alta and 96 in for the Trio Alta, and says it can special order cars 4 in shorter.

Capacity and Wheelchair Access

If a wheelchair is involved, the choice narrows to the Stiltz Trio Alta or the PVE52.

  • Trio Alta: 31 1/2 in clear entrance, level access with an integral ramp available, and 550 lb for "a full-sized wheelchair and a helper," per Stiltz.
  • PVE52: 32 in entrance and 525 lb. PVE says it carries three people, or two if one is in a wheelchair.

Weigh the chair, the rider and any helper together before you choose.

Power Needs

Neither runs on a regular US 120V outlet.

  • Stiltz's FAQ says its lifts "run on a standard dedicated 220v wall outlet" and use about as much electricity as a dishwasher. The Trio Alta spec sheet lists 220 to 240V at 10 to 20A.
  • PVE's spec sheets call for 220 to 240V single phase at 30A (PVE30, PVE37) or 40A (PVE52). Its maintenance manual asks for a "regulated, clean, and dedicated line."

Angi lists adding a 220V circuit at $140 to $320, and a panel upgrade at $500 to $2,200 (read Nov 20, 2026). Have a licensed electrician check your panel.

Power Outages

  • Stiltz: Every lift has a battery backup that will "gently lower the elevator cabin and any travelling occupants to the lower level," according to Stiltz. An optional UPS allows "numerous trips both up and down" during an outage.
  • PVE: No battery is needed. PVE's spec sheets say the car "automatically descends to ground level at safety speed." It cannot go up until power returns.

Installation and Structure

Stiltz's FAQ says a standard install "will usually take one to two days," done by an authorized dealer, after any home modification is finished. The dealer cuts a floor opening, which is 50 3/8 x 41 1/4 in for the Trio Alta.

PVE says its installs can take "as little as two to three days." The ground floor "must be 100% level," and upper floors need a round cutout of 32, 39 or 54 11/16 in depending on model. Real jobs can run longer: Fine Homebuilding's 2019 story on a PVE52 retrofit reported 350 hours of builder prep and a six day, four person install.

Noise, Temperature and Service

Noise. Stiltz's FAQ calls its lifts "very quiet," quieter "than many stairlifts," but gives no decibel figure. PVE quotes about 50 dB for its outdoor split unit. Two dealers that sell PVE-type elevators, Home Elevators of Austin and Home Elevator of Houston, say most vacuum elevators reach up to 85 dB, mostly going up.

Temperature. PVE's maintenance manual says not to use the elevator below 65°F (18°C). We found no similar limit in the Stiltz documents we read.

Service. Stiltz recommends service once a year by an authorized dealer. PVE's manual recommends a check every 6 months by a PVE-trained technician only.

Code and Permits

Both brands point to ASME standards, but in different ways. PVE describes its units as ASME A17.7 compliant. Stiltz says its lifts follow ASME A17.7, which it describes as recognized by A17.1, and ASME A18.1, the platform lift standard. ASME A17.1 Section 5.3 covers private residence elevators.

How a state classifies a lift matters. In June 2025, the Massachusetts Board of Elevator Regulations granted a product variance letting the Stiltz Duo Alta run at 375 lb under ASME A18.1, Section 5.7.1, with site specific drawings required for each permit. Georgia's residential elevator checklist cites A17.1 Section 5.3 and requires a permit before installation and an inspection before use.

Rules vary. Let a licensed installer and your local elevator inspector confirm what applies before you buy.

Published Cost Ranges

Neither brand posts prices. Third party ranges, as listed on the date shown:

SourceStiltzPneumatic vacuum (PVE type)
Fixr (updated Jan 31, 2025)$20,000 to $25,000 average installed$35,000 to $60,000 installed, about $50,000 average
RetirementLiving (read Nov 20, 2026, no date on page)Duo from about $20,000 to $25,000; Trio from about $30,000 to $35,000PVE usually $35,000 to $60,000
Angi (read Nov 20, 2026, no date on page)not listed$30,000 to $75,000, about $45,000 average, plus $5,000 to $15,000 install

These are estimates. Floors served, finishes, electrical work and permits change the total. Get written quotes.

Who Should Buy Which

Choose Stiltz if:

  • You have two floors (Duo) or up to three (Trio Alta)
  • You need a wheelchair plus helper and want the lower published cost range
  • The space may drop below 65°F
  • You want backup trips up and down in an outage (optional UPS)

Choose PVE if:

  • You need up to 5 stops or 50 ft of rise
  • One rider and a very small footprint matter most (PVE30)
  • You like the clear tube and want gravity descent with no battery

Who Should NOT Buy Either

  • Households that need 1,000 lb or more of capacity. Dealers note traditional elevators handle that.
  • Anyone who can't add a dedicated 220V circuit
  • Homes far from an authorized dealer for the brand

FAQ

Does a Stiltz plug into a normal outlet? It plugs into a dedicated 220V outlet, per Stiltz, not a standard 120V US outlet.

Which is quieter, Stiltz or a vacuum elevator? Stiltz gives no decibel figure. PVE quotes about 50 dB for its split unit, and two dealers say vacuum units reach up to 85 dB going up.

Which is better for a wheelchair? Only the Stiltz Trio Alta (31 1/2 in entrance, 550 lb) and the PVE52 (32 in, 525 lb) qualify.

Can either go to three floors? Yes. Stiltz lists the Trio Alta for up to three floors (19 ft 8 1/4 in of travel), using an extended travel version. PVE models serve up to 5 stops.

Sources

Price-check any of these at 36 storesAmazon isn't always cheapest — live prices where we can read them, one-tap links where we can't.
📬

Get the Best Deals & Honest Reviews in Your Inbox

Weekly picks, price drops, and buyer guides — no spam, ever.

Related Articles